Strain gauge transducer amplifier
Digital display module
Limit trips
Voltage / 4-20mA output
Simple trimpot controls
Signal conditioning is required where the output of a transducer needs to be boosted or changed into a form suitable for the monitor or logging device which will be used. Our digital display units have a built-in monitor device in the form of the digital display as well as analogue output.
The E308 has high and low limits with voltage-free relay outputs. The E308 has a shunt calibration facility to enable calibration checks to be made.
A very wide range of gain adjustment ensures that our amplifiers are compatible with the vast majority of dc and strain gauge sensors available from any manufacturer.
Although they have a digital display, these units are entirely analogue and are configured using switches and potentiometers, there is no set-up software to learn.
The E308 has high and low limits with voltage-free relay outputs. The E308 has a shunt calibration facility to enable calibration checks to be made.
A very wide range of gain adjustment ensures that our amplifiers are compatible with the vast majority of dc and strain gauge sensors available from any manufacturer.
Although they have a digital display, these units are entirely analogue and are configured using switches and potentiometers, there is no set-up software to learn.
Panel cut-out = 5.47'' X 2.64''
PMBH = 2.83''
PMBH = 5.67''
PMD = 7.28''
PMDC = 9.65''
PMHH = 3''
PMHW = 5''
Specification